Ghost Multicasting :: essays research papers

Phantom Multicasting permits one PC, the Ghost Server, to download a Ghost picture from the Server and afterward diverts the picture to different workstations, the Ghost Clients, using TCP/IP settings over the system. The primary bit of leeway of Ghost Multicasting is that the downloading time is very abbreviated as just a single PC is downloading the picture off the Server which significantly diminishes the danger of substantial system traffic. The main impediment is that the PC picked to be the Ghost Server must have enough free hard drive space to store the picture which will at that point be redistributed. The Two Methods Of Ghost Multicasting. Physically Specified Ghost Multicast †Utilizing this strategy you need to physically appoint novel IP addresses for the Client PCs by utilizing and arranging the wattcp.cfg record situated on each Clients’ boot circle. Naturally Specified Ghost Multicast †This subsequent strategy is by utilizing Windows NT to naturally dole out IP delivers to the Client PCs by the utilization of the Dynamic Host Configuration Protocol, or DHCP, remembered for Windows NT ver. 4.00. Physically Specified Ghost Multicasting: Setting Up Ghost Server Disk 1. Set up a boot circle that incorporates and stacks the vital system drivers and maps the plate pictures registry from the system. 2. Duplicate over the DOS Ghost Server program (dosghsrv.exe) to a similar plate and add it to the autoexec.bat document. 3. Duplicate over the wattcp.cfg record to the plate and change the IP Address, Subnet Mask and Gateway as per arrange. (An exceptional IP Address ought to be distributed for the Server PC) Setting Up Client Disks 1. Get ready boot circles in a similar request for the server boot plate however duplicate over ghost.exe rather than dosghsrv.exe. 2. Alter the wattcp.cfg and include a novel IP Address for each boot plate. (Generally IP Addresses would have been set up before for the particular utilization of distinguishing apparition customer PCs) Ghosting Client PCs 1. Burden up the PC which will go about as the Ghost Server with the Server Boot Disk and burden dosghsrv.exe from the DOS order brief. 2. Type in a Session Name and select the Image File from the circle pictures index on the system. 3. Start up Client PCs with the remarkable Boot Disks and burden ghost.exe. From the Ghost Server, you should see the IP Addresses of the Clients show up in the window as every Client PC stacks the Ghost program. 4. When each Client PCs’ IP Address can be found in the Ghost Server window, you can choose them all by tapping on Accept Clients.